BFI-Elektronik   BFI-Elektronik
Configuration

Special design request

Sender
first name:
family name:
company:
street/number:
ZIP/city:
country:
phone:
Output voltage
minimum adjustable ionizer voltage: kV
maximum adjustable ionizer voltage: kV
positive output voltage (standard)
negative output voltage
Ionizer/Collector voltage ratio:
2:1 (standard)
3:2
3:1
4:1
3:4
Overcurrent shutdown
sum current limit mA
turn-off after overcurrent shutdowns
error counter reset after s (tRESET_Fehlerzähler)
turn-off time taus: s
smooth start-up time tAnlauf: s
Stepper
Should the device contain a stepper?
no (standard)
yes
number of errors which cause reducing of output voltage by one step:
time span tRESET_StepperFehlerzähler which causes a reset of the stepper error counter if no overcurrent error occurs: s
time span tStepUp which causes increasing of output voltage by one step if no overcurrent error occurs: s
steps:
2
4
8 (Standard)
voltage difference between two steps: V
LED function '
Colour LED 1 (control)
green (standard)
red
yellow
white
blue

function LED 1 (control)

Colour LED 2 (service)
green
red (standard)
yellow
white
blue

function LED 2 (service)

Should the device contain a third LED?
no (standard)
yes

Colour LED 3 (Stepper)
green
red
yellow (standard)
white
blue

function LED 3 (Stepper)
Output function
use relay for output K1 (standard)
configure output K1 to connect a LED directly

function output K1

function output K2
Pollution detection
Should the device contain a pollution detection?
no (standard)
yes
Current threshold (% of max. output current): %
Time span during current drain must be greater than current threshold to report filter pollution: s
Time span during current drain must be smaller than current threshold to leave filter pollution mode: s
Top cover print
Should the top cover imprinted with a special label?
yes
no (standard)
Comment